Objectives:
- To understand the use of Standard Method of Measurement (SMM II) and Malaysia Civil Engineering Standard Method of Measurement (MYCESMM) in M&E, Civil Engineering , plumbing works, soil waste and sanitary appliances works.
- Able to apply appropriate clauses and rule of measurement in SMM II and MYCESMM to the relevant element.
- Able to understand and analysis the drawing in order to carry out an accurate measurement thereby to produce a Bill of Quantities.
Chapters Covered:
According to SMM II
- ELECTRICAL INSTALLATION
- COLD WATER INSTALLATION
- SANITARY INSTALLATION
- AIR CONDITION INSTALLATION
- FIRE PROTECTION INSTALLATION
According to MYCESMM
- CLASS D - SITE INVESTIGATION
- CLASS B - ENVIROMENTAL PROTECTION.
- CLASS F - EARTHWORKS
- CLASS G - GEOTECHNICAL WORKS
- CLASS I - PRESTRESS CONCRETE
- CLASS S - RAILTRACK
Assignments done:
Firstly we had a class test to test our knowledge on the subject during the first half of the semester.
 |
| Electrical Installations in a house |
We were afterwards given a group assignment on the topic of Cold Water Installation. We were asked to measure the cold water installation for an intermediate unit of a terraced house.
Reflections:
By continuously attending the lecture and tutorial class, i am able to have a well-understanding in plumbing, soil pipe, sanitary appliances, M&E, and all civil engineering work.
I am able to understand and apply the rules of measurement as stipulated in SMM II and MYCESMM.
By conducting the group assignment assigned, i am now fully able to apply what had been taught in class into the assignment thereby successfully carry out the task assigned and hand in on time. By doing the assignment, i can practice and strengthen my measurement skill on the "Cold Water Installation" and deepen my understanding and skill on the topic.
Besides, i have gained a lot of knowledge and skill from both lecturer (Mr. Ramar & Mr. Simon) which I am sure I shall fully utilize all the skill and knowledge in the near future.
No comments:
Post a Comment